Creator Electronics Digital Conference System Uživatelský manuál stáhnout pdf (Strana 16)

CREATOR CHINA 2012-05 WWW.CREATOR1997.COM

User's Manual of DIG series Full Digital conference

system

PC Status: display whether connect to PC

software

2.1.5.4.2 Volume Settings

Line in: Adjust the input volume of line In.

Treble: Adjust the conference unit fidelity

audio treble and line output treble.

Bass: Adjust the conference unit fidelity audio

bass and the bass of line output.

Line out: adjust the volume of conference unit

fidelity audio and line output

Infrared: adjust the volume of interpreters

output channel (corresponding to the CR-

DIG5201 rear panel ⑦ CH0 ~ CH15 ⑧

microphone, separate output). Note that CH0 is

original sound, only be adjusted by the Infrared

menu, cannot be controlled by treble, bass,

Line-out menu, and have no AGC ANC AFC

function.

2.1.5.4.3 Unit Management

1、 start coding ID

◆ the so-called conference unit ID setting, refer

to endow a unique address to every conference

unit (including the translation unit and speak unit)

for host identification.

◆ Steps of coding ID

After connecting the conference system,

open the conference host power, select the "unit

management" and “start coding ID”, the display

shows as follows:

All speech units and translation units display

as follows：

Speech units display：

Translation units display：

At this point press microphone buttons of

conference unit one by one to set ID. Conference

unit microphone button indicators blink once or

stay lit, suggesting that the current ID is unique. If

the button indicators blink several times and then

stay lit, indicating that at least there are 2

machines having the current ID. Conference unit

microphone button indicators stay lit, the setting

of ID is successful. However, if the indicator light

keeps blinking, the setting of ID is unsuccessful.

After finishing the setting, press “Stop Coding

ID ” to exit setting. When all the indicators

extinguish, the system enters the normal state. If

the ID repeats, microphone key indicator of

repeated ID conference unit will flash, thus the

repeated ID should be reset. The host system

information menu will warn about the repeated ID

as well.

When the host is re-powered, the system will

automatically detect that whether the ID is

repeated.

2、 the scanning unit

Select the scanning unit to display system state of

conference unit, including the number of system

meeting units, the number of Chairman units, the

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 61 62

Komentáře k této Příručce

Žádné komentáře

Creator Electronics Digital Conference System Uživatelský manuál Strana 16

Komentáře k této Příručce